Philips AVENT SCD833 Manual Del Usuario página 8

8
English
3 hrs = 10 hrs
1
Eco 20°C
Using the baby monitor
Linking parent unit and baby unit
-
When you charge the parent unit for 3 hours, it can be used cordlessly
for approx. 10 hours in ECO mode.
- If the parent unit is switched on during charging, charging takes
approximately twice as long.
-
When the rechargeable battery of the parent unit is almost empty, the
battery status light turns red and the parent unit beeps.
-
If the battery is completely empty and the parent unit it not connected
to the mains, the parent unit automatically switches off and loses
contact with the baby unit.
Note: The built in rechargeable battery cannot be removed from the
product.
Note: The battery gradually and very slowly discharges, even when the
parent unit is switched off.
Tip: To save battery, switch off the parent unit when you do not use it.
Note: We advise you to keep the parent unit connected to the mains
during the whole night. If the battery of the parent unit runs low during
the night, the parent unit beeps and this may wake you up.
1 Push the on/off slide on the baby unit upwards to the ON position.
2 When the baby unit is on, the power-on light on the baby unit lights up
green.
Note: The power-on light on the baby unit always lights up green, even
when there is no connection with the parent unit.