UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
GENERAL
1.
On/Off
Dial "ON" to turn on the unit. Dial "OFF" to turn off the unit.
2.
Mode Button
Press repeatedly to switch between USB, microSD, AUX, BT modes.
Noted, in case of two partyspeakers! The 1st speaker change to BT mode and play the music . Then change mode to
BT for 2nd speaker, press the 1st speaker "mode" button for 3seconds till hear the 2nd speaker have "di". Then two
speakers are connected sussessfully.
3.
Scan Button
In FM mode, press to start autoscan. The available FM channels will be saved to preset memory positions.
4.
BT speaker phone Button
In BT mode, short press to answer the phone; long press to reject the phone and hang up the phone when there is an
incoming call.
5.
Previous/Volume- Button
Press to play the previous music track or previous radio station.
Long press for the volume increase.
6.
Next /Volume+ Button
Short press to play the next music track or next radio station.
Long press for the volume reduction.
7.
USB Input
Connect your USB devices to this slot to play music with MP3-format on USB mode.
8.
MicroSD input
Add a microSD card to this socket to play back music on the card.
9.
Aux Input
3.5mm jack connector for input from mobile phone, tablet, PC etc.
10. Charging Input
DC 5V microUSB input for battery charging.
BT CONNECTION
Place the speaker within 10 metres of the BT enabled device. Press the mode button until you are in BT mode. Then use your
mobile or other BT device and search the speaker. The BT name for this speaker is "SBS80 Speaker".
4