Domo DO9253IB Manual De Instrucciones página 23

PARTS
1. Water tray
2. Freeze fingers
3. Ice shovel
4. Full basket sensor
5. Ice basket
6. Control panel
7. Ventilation opening
8. Drain hole with plug
9. Scoop
CONTROL PANEL
10. Indicator light 'water reservoir empty'
11. Indicator light 'ice basket full'
12. Indicator light 'in operation'
13. On/off button
10 11
BEFORE THE FIRST USE
· Make sure all packaging materials and promotional stickers have been removed before using the
appliance for the first time.
· Before using the ice cube maker for the first time: wait 2 hours after putting the appliance in place and
leave the lid open for at least 2 hours.
· Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are
not blocked.
· Clean the device according to the instructions in the 'Cleaning and maintenance' section.
USE
1. Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are
not blocked.
2. Open the lid and take out the ice basket so you can pour water into the water tank. It is
recommended to use spring water or mineral water.
! Caution: Make sure that the water level is lower than the maximum indication. If the water tank
is filled above the MAX indication, drain the excess water through the drain hole at the bottom of
the ice cube maker. Open the drainage hole on the underside of the appliance above a collecting
container or a sink. Always ensure that the opening is closed properly before use.
! Use water at room temperature. The recommended temperature is between 8°C and 25°C.
www.domo-elektro.be
4
5
12 13
1
9
2
3
6
7
8
23
DO9253IB