Domo DO9253IB Manual De Instrucciones página 24

Idiomas disponibles

Place the basket back into the appliance and close the lid.

Plug the power cord into a socket. The 'in operation' indicator light will start flashing. Press the on/

off button on the appliance to turn it on. The indicator light comes on and the ice-making cycle

starts.

When the cycle is over, the ice cubes fall from the cold fingers and are pushed by the ice scoop into

the ice basket. The following cycle starts automatically. If you do not remove the ice cubes from the

ice basket, they will gradually melt. The meltwater is captured in the water reservoir for reuse.

When the desired amount of ice is ready, you can switch off the device by pressing the on/off button.

Unplug the power cord after use.

Clean the appliance after each use. Empty the water reservoir before storing the appliance. Open

the drainage hole on the underside of the appliance above a collecting container or a sink.

! During the first 3 cycles, the ice cubes may be smaller and more irregular in size. When the ice basket

is full, immediately remove the ice from the ice basket.

●

If the 'water reservoir empty' indicator lamp lights up, there is not enough water left in the water

ADD WATER

reservoir. Fill the water reservoir with water and press the on/off button to restart the machine. If

you do not press the on/off button after the reservoir is full, the device will automatically restart

after 30 minutes.

●

If the 'ice basket full' indicator light flashes, the machine will stop working. Empty the ice basket.

ICE FULL

If there is no more ice near the sensor, the appliance will restart automatically.

CLEANING AND MAINTENANCE

! Never immerse the appliance, the cord or the plug in water or any other liquid.

Switch off the appliance and unplug before cleaning. Also remove all ice cubes.

Drain all water from the water tank through the drain hole at the bottom of the

ice cube maker. Open the drainage hole on the underside of the appliance above

a collecting container or a sink.

Regularly clean the ice basket, the water tank, the water tray, the freeze fingers

and the ice shovel. Use a damp cloth, maybe with a little mild detergent, to

clean the inside and the outside of the ice cube maker. Rinse thoroughly before

using the appliance again.

Do not use any chemical products or products containing acids, gasoline or oil.

Do not use any mechanical appliances or other aids to speed up the freezing process.

Replace the water in the water tank at least once a day to guarantee clean ice cubes. When not using

the appliance, always drain the water from the water tank. Always use clean water when using the ice

cube maker.

DO9253IB