Publicidad
Idiomas disponibles
Idiomas disponibles
Do not operate the tool without the
WARNING
front handle in place. The front
handle must be attached properly for use when
trimming. Using one hand could cause loss of
control and result in serious injury.
Installing the Front Handle
The front handle is shipped uninstalled
and must be installed before use.
1. Place the two nuts into the front
handle detents.
2. Insert one bracket into the handle.
3. Alight the front handle with the top
of the warning sticker, just above
the "Place Handle Here" marking.
4. Wrap the other bracket around the
back of the shaft.
5. Insert the two screws through the
lower bracket and into the side
handle.
6. Tighten the screws securely using
the included key.
Adjusting the Cutting Diameter
(16")
To change the cutting diameter from 14" to 16":
1. Remove the battery pack.
2. Remove the two screws holding the line cut-off
blade.
3. Rotate the blade 180° and reinstall the screws.
Tighten securely.
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
(14")
Do not use blades, brush cutting
WARNING
wheels, accessories, or attach-
ment other than those recommended by
MILWAUKEE. Serious injury or product damage
may occur.
Replacing the Cutting Line
Use only MILWAUKEE trimmer line (see Specifica-
tions). Replace the cutting line with either 20' of .095
spiral line or 25' of .080 spiral line. Note, when used
near abrasive surfaces or in dense growth, the cutting
line will wear faster.
1. Remove the battery pack.
2. Clean any grass or debris from the trimmer head.
3. Measure out 20' of .095" spiral line or 25' of
0.080" spiral line. CAUTION: When replacing
the line, use only MILWAUKEE 0.080" or 0.095"
(2 mm or 2.4 mm) diameter spiral line. Any other
line can degrade performance or cause damage
to the trimmer.
4. Rotate the cap to align the red indi-
cators on the cap with the red indi-
cators above the eyelets.
5. Insert the line through either eyelet
and push through the head so an
equal amount of line extends from
each eyelet.
6. Begin winding the line by rotating
the cap in the direction of the
arrows. Continue twisting until 4"
to 6" of line extends from the
eyelets.
7. Check that the exposed line
extends no further than the line
blade. If the exposed line is too
long, continue winding the cap
or trim before use.
8. Under normal operation, the remaining string
should be thrown from the spinning head during
use. If any string remains in the head, or to remove
a length of string to replace with a different type,
turn the trimmer head over and press the release
tabs. Remove the housing from the trimmer head
to access the remaining line on the spool.
9. Remove the line and replace the housing by align-
ing it with the ring. Press until it clicks into place.
Remove the cover away from the head. Discard
any short line remnants. Snap the cover back onto
the trimmer head.
Selecting the Speed
Use the speed control button to select Low
or High speeds. Use low speed for larger
jobs where extended battery life is needed.
Use high speed for dense growth applica-
tions.
5
Low
High
Publicidad
