Cooper Security Scantronic 771r Manual De Instrucciones página 10

NOTE: Ensure that the INFO module has already learned the identity of the
7500r control unit. Make sure that a link is fitted across at least one
pair of the partition select pins.
To carry out a signal strength test:
1. At the 7500r control unit, enter Installer Mode and select Other Devices - Info
Module Menu.
2. Press TEACH.
3. At the INFO module, operate the signal strength switch (use a short length
of stiff wire through the hole at the bottom of the case).
The display shows the strength of the signal from the control unit. The more
LEDs there are alight, the stronger the signal. If only two LEDs or fewer are
alight then the signal is not strong enough for reliable operation.
4. Testing
10