Optimus UMX-SYL Instrucciones De Operación página 5

8) CHANNEL "B". Set of elements belonging to channel B. They have the same functionalities as the elements of channel A,
applied in this case to channel B (with the exception of the connection of Pin 8 to ground and the shield of connector RJ45 B,
which is accomplished by internal jumper JP1
Internal jumper JP6).
3. CONFIGURATION
Configuration of the
FAIL and priority
contact for channel B
SW2 and JP4
UMX-SYL version 4.2.000
and the connection to the earth of the equipment witch is made through the
,
Connection to ground (GND)
of pin 8 and the shield of
connector RJ45 for CHANNEL "A"
JP3
Figure 2
SW1 and JP2
Configuration of the
FAIL and priority
contact for channel A
UMX-SYL
Figure 3
FAIL CONTACT
SCHEME
* Open collector output
Voltage free contact
*
Factory settings
Card with two audio outputs
with surveillance functions and redundancy
Connection to earth
of the equipment
of pin 8 and the shield
of connector RJ45
for CHANNEL "A"
Connection to earth
of the equipment
of pin 8 and the shield
of connector RJ45
for CHANNEL "B"
Connection to ground
(GND) of pin 8 and the
shield of connector RJ45
for CHANNEL "B"
RJ45 CONECTOR
PRIORITY CONTACT SCHEME
* Open collector output
Voltage free contact
JP5
JP6
JP1
Figure 4
5