Publicidad
Idiomas disponibles
Idiomas disponibles
74
ASSEMBLY
Follow the following assembly instructions:
1.
Insert a wheel axle (A) through each wheel (B).
2.
Push each axle into the frame axle tube (C).
3.
Insert a "R" clip (D) through the hole in the axle, so the axle is secured.
B
ATTENTION: The handle can be inserted with the clamping curve facing both sides. Take this into
account when mounting the hose coil to the handle, as the coil must be mounted so that the pump
connection is on the left hand side of the machine. The coil can be installed so that the attachment
of the pump connection hose and the rewinder fit both in front of and behind the handle.
4.
Slide the coil clamps (F and G) over the handle tubes (E) at approximately 150mm (6"). Screw the clamps
to the handle with the 4 screws M6x15 (H) and locknuts (I), there are locks in the nut clamps. Tighten the
screws (turn clockwise) with the screwdriver.
F
E
5.
Insert the handle (E) into the frame tubes (J). Press the spring pins (K) inward so that the handle tube can pass
over them. When the pins "jump" through the holes in the handle, the handle has been mounted correctly.
J
A
G
I
E
C
H
K
D
Publicidad
