Descargar Imprimir esta página

Blomberg BRFT1622 Serie Manual Del Usuario página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

Hot Surface Warning !
Side wall of your product is equipped
with refrigerant pipes to improve the
cooling system. Refrigerant with high
temperature may ow though these
areas, resualting in hot surfaces on the
side wall this is normal and does not
need any servicing.Plase pay attention
while touching these area.
4
Preparation
• Your cooler/freezer should be installed at least 30 cm away from
heat sources such as hobs, ovens, central heater and stoves and
at least 5 cm away from electrical ovens and should not be located
under direct sunlight.
• Please make sure that the interior of your cooler/freezer is
cleaned thoroughly.
• If two coolers are to be installed side by side, there should
be at least 2 cm distance between them.
• When you operate your cooler/freezer for the rst time, please
observe the following instructions during the in itial hours.
• Its door should not be opened frequently.
• It must be operated empty without placing any food in it.
• Do not unplug your cooler/freezer. If a power failure occurs
out of your control, please see the warnings in the
"Recommended solutions for the problems" section.
• The baskets/drawers that are provided with the chill
compartment must always be in use for low energy
consumption and for better storage conditions.
• Food contact with the temperature sensor in the freezer
compartment may increase energy consumption of appliance.
Thus any contact with the sensor(s) must be avoided.
• This product has been designed to function at ambient
temperatures up to 43°C (90 SDgr F). Even if the ambient
temperature falls to -15°C, frozen food in the freezer
does not thaw thanks to its Advanced Electronic Temperature
Control System. For the rst installation, the product should
NOT be placed underlow ambient temperatures. This is because
the freezer cannot go down to standard operation temperature.
When reaching continuous operation, the product can be moved
to another place. Thus, later you can place your product in the
garage or an unheated room without the concern of causing frozen
food to get rotten. However, it is likely that above mentioned low
temperatures may cause the freezing of the food in the fridge
compartment; thus, please consume the food items in the fridge
in a controlled way as needed. When ambient temperature goes
back to normal, you may change button setting according to
your need.
• If the ambient temperature is below 0°C , the food in fridge
compartment will freeze. Therefore, we recommend not
using the fridge compartment in such low ambient temperatures.
You may continue to use the freezer compartment as usual.
• In some models, the instrument panel automatically turns
off 5 minutes after the door has closed. It will be reactivated
when the door has opened or pressed on any key.
• Due to temperature change as a result of opening/closing
the product door during operation, condensationon the
door/body shelves and the glass containers is normal.
5
Using your refrigerator
Indicator panel (Internal Display) *Optional
Indicator panels may vary according to the product model.
Audio – visual functions on the indicator panel helps you in
using your product.
8
9
*optional
Figures that take place in this instruction manual are
schematic and may not correspond exactly with your
product. If the subject parts are not included in the product
you have purchased, then it is valid for other models.
1. Freezer compartment indicator
Fridge compartment light is illuminated while the freezer
compartment temperature is set.
2. Error status indicator
If your refrigerator does not perform enough cooling or in
case of a sensor fault, this indicator is activated.When this
indicator is activated, "E" is displayed on the freezer
compartment temperature indicator, and numbers such
as "1,2,3..." are displayed on the fridge compartment
temperature indicator. These numbers on the indicator
inform service personnel about the error.
3. Temperature indicator
Indicates freezer, fridge compartment temperature.
4. Vacation function button
Press on Vacation Button for 3 seconds to activate this
function.When the vacation function is activated, "- -" is
displayed on the fridge compartment temperature indicator
and no active cooling is performed on the fridge
compartment. It is not suitable to keep the food in the fridge
compartment when this function is activated.
Other compartments shall be continued to be cooled as
per theirset temperature.To cancel this function press
Vacation
button again.
5. Temperature setting button
Changes the temperature of the relevant compartment
between -24°C... -18°C and 8°C...1°C.
6. Compartment selection button
Selection button: Press compartment selection button to
switch between fridge and freezer compartments.
7. Fridge compartment indicator
Fridge compartment light is illuminated while the fridge
compartment temperature is set.
8. Economy mode indicator
Indicates that the refrigerator operates in energy saving
model.This display shall be activated if the freezer
compartment temperature is set to -18°C.
9. Vacation function indicator
Indicates that vacation is activated.
10. Icematic function (optional)
Indicates whether the icematic is on or o .(
then the icematic is not operating.To operate the icematic
again press and hold the On-O button for 3 seconds.
6
EN
2
3
1
10*
7
6
5
4
)If On,

Publicidad

loading

Este manual también es adecuado para:

Brft1622ss