Publicidad
Idiomas disponibles
Idiomas disponibles
14
ASSEMBLiNG ANd PREPARiNG
Mounting on a table
1
Lift and tilt the TV into its upright position on a table.
- Leave a 10 cm (4 inches) (minimum) space from
the wall for proper ventilation.
10 cm
10 cm
2
Connect the power cord to a wall outlet.
cAuTiON
Do not place the TV near or on sources of heat, as
y
y
this may result in fire or other damage.
Securing the TV to a table
(Except 55LN541C, 55LN549E)
Attach the TV to a table to prevent from tilting forward,
damage, and potential injury.
Mount the TV on a table, and then insert and tighten the
supplied screw on the rear of the stand.
WARNiNG
To prevent TV from falling over, the TV should be
y
y
securely attached to the floor/wall per installation
instructions. Tipping, shaking, or rocking the TV
may cause injury.
Adjusting the angle of the TV to suit view
(For 32LN541C, 32LN549E, 32LP560M)
Swivel 15 degrees to the left or right and adjust the
angle of the TV to suit your view.
m
1 0 c
10 cm
(For 39/42/47/55LN541C, 39/42/47/55LN549E,
42LP560M)
Swivel 90 degrees to the left or right and adjust the
angle of the TV to suit your view.
y
15˚
90˚
cAuTiON
When adjusting the angle of the TV, watch out for
y
your fingers.
- Personal injury may occur if hands or fingers are
pinched. If the product is tilted too much, it may
fall, causing damage or injury.
15˚
90˚
Publicidad
