Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS(optional)
Window
panel
Foam seal
11
Installation in a sliding sash window
1. Cut the foam seal(adhesive type) to the proper length and
Foam seal A
(adhesive type)
attach it to the window frame. See Fig.12.
2. Attach the window slider kit to the window stool. Adjust the
length of the window slider kit according to the width of
window, shorten the adjustable window kit if the width of
Fig.12
window is less than 26.5 inches.
Open the window sash and place the window slider kit on
the window stool. See Fig.13.
26.5 ~ 48.0
3. Cut the foam seal(adhesive type) to the proper length
and attach it on the top of the window. Shown as in Fig.14.
4. Close the sliding sash securely against the window.
Fig.13
5. Cut the foam seal to an appropriate length and sea the
open gap between the top window sash and outer window
sash. Shown as in Fig.15.
NOTE:All the illustrations in this manual are for explanation
Fig.14
Fig.15
purpose only.Your unit may be slightly different. The
actual shape shall prevail.
Publicidad
