HH Electronics TNA-1800S Manual De Instrucciones página 3

L INE ARRAY
SUSPENSION
TNA-1800S cabinets are fitted with 6 x M10 flying points for installation and suspended use.
Suspension and installation of the TNA system MUST be performed by a qualified and certified installation
engineer and must abide by safety regulations within your region. Failure to do so could result in serious injury
or death!"
1 1
Remove the 6 x M10 x 30mm travel bolts and store for future use. Their locations are shown below:
LEFT
2 2
Replace with suitable M10 eye bolts.
Ensure their threads are fully engaged into the inserts.
M10 thread
Note that eye bolts for flying systems must be cast, Note that eye bolts for flying systems must be cast,
shouldered fittings rated for the purpose. shouldered fittings rated for the purpose.
Forged steel eye bolts of the type typically available Forged steel eye bolts of the type typically available
from DIY suppliers are NOT suitable and should from DIY suppliers are NOT suitable and should
not be used under any circumstances. not be used under any circumstances.
All suspension cables, shackles and other mounting All suspension cables, shackles and other mounting
hardware must be properly secured to the eye hardware must be properly secured to the eye
bolts and be capable of exceeding max load. bolts and be capable of exceeding max load.
Do not fly multiple cabinets together, each must be Do not fly multiple cabinets together, each must be
flown on their own. flown on their own.
© 2020 HH Electronics Ltd
TOP
20mm minimum thread length
Designed and Engineered in the UK by HH Electronics LTD.
ARRAY
RIGHT REAR
3