Publicidad
Idiomas disponibles
Idiomas disponibles
Connection
2 WARNING
To prevent fire caused by a short in the wiring,
connect a fusible link or breaker nearby the
battery's positive terminal.
2 CAUTION
• If sound is not output normally, immediately
turn power off and check connections.
• Be sure to turn the power off before changing
the setting of any switch.
• If the fuse blows, check wires for shorts, then
replace the fuse with one of the same rating.
• Check that no unconnected wires or connectors
are touching the car body. Do not remove
caps from unconnected wires or connectors to
prevent short circuits.
• Connect the speaker wires to appropriate
speaker connectors separately. Sharing the
negative wire of the speaker or grounding
speaker wires to the metal body of the car can
cause this unit to fail.
• After installation, check that the brake lamps,
winkers, and wipers work properly.
■ LX-Bus connection
CENTER UNIT
Power control wire
FUSE(30A×2)
POWER IN
Master amplifier
Extension wire*
FUSE(30A×2)
POWER IN
Slave amplifier 1
FUSE(30A×2)
POWER IN
Slave amplifier 7
4
English
Power control wire
Terminal cover
Battery wire*
Protective Fuse*
Battery
Ground wire*
To Kenwood disc changer/
External optional accessory
Control cable
(option)
ID NUMBER
TO H/U
REMOTE
RESET
"0"
ID NUMBER
S-video cable*
ID NUMBER
TO H/U
REMOTE
RESET
"1" – "7"
ID NUMBER
Not more than
14m (46 ft)
ID NUMBER
TO H/U
REMOTE
RESET
"1" – "7"
ID NUMBER
CENTER UNIT
(CD receiver, etc.)
RCA cable ground
Lead terminal*
terminal
FUSE(30A×2)
POWER IN
Set the ID number of the Master amplifier to "0".
You can connect up to 7 Slave amplifiers. Assign them ID numbers "1"
to "7" and do not duplicate them.
2 CAUTION
• Do not connect 2 Master amplifiers to the Center Unit. If done, you
cannot control all amplifiers connected to the Center Unit.
• The LX AMP and the sensor unit cannot be connected
simultaneously. You must connect any of them at a time.
NOTE
• The total length of S-video cables you can connect is 14 meters
(46 ft) maximum. If the cable length exceeds this limit, you cannot
control amps from the Center Unit.
• If you assign the same ID number to multiple amplifiers, they
malfunction when you operate any of them from the Center Unit.
• If you assign ID number "8" or "9" to a Slave amplifier, it is not
recognized by the Center Unit.
RCA cable*
* Commercially available parts
RCA cable*
B channel
input
A channel
input
ID NUMBER
TO H/U
REMOTE
RESET
A channel
Right speaker
A channel
Left speaker
B channel
Right speaker
B channel
Left speaker
■ Bridged Connections
A channel
Speaker (Bridged)
B channel
Speaker (Bridged)
Publicidad
