PREPARATION
ACCESSORIES
Ensure that the following accessories are included with your TV. If an accessory is missing, please contact the
dealer where you purchased the TV.
The accessories included may differ from the images below.
Owner's Manual
Protection Cover
(Refer to P.16)
Polishing Cloth
(Not included with all models)
The ferrite core can be used to reduce the electromag-
netic waves in the PC Audio cable.
Wind the PC Audio cable on the ferrite core twice, and
Ferrite Core
then plug the cables into the TV as shown in the fol-
(Gray)
lowing picture.
(This feature is not
Place the ferrite core close to AUDIO IN(RGB/DVI) jack
available for all
on the display.
models.)
Place the ferrite core close to
AUDIO IN(RGB/DVI) jack on the display.
All manuals and user guides at all-guides.com
CD Manual
(Except
60PK250,
60PK550, 60PK280, 60PK290,
60PK550C)
x 4
M4x28
Bolts for stand assembly
(Refer to P.15)
* Wipe spots on the exterior only with
the polishing cloth.
* Do not wipe roughly when removing
stain. Excessive pressure may cause
scratch or discoloration.
AUDIO IN
(RGB/DVI)
or
1.5V 1.5V
Remote Control,
Batteries
60PK540,
x 3
M5x14
O O p p t t i i o o n n E E x x t t r r a a s s
When using the VGA (D-sub 15 pin
cable) PC connection, the user must
use shielded signal interface cables
with ferrite cores to maintain stan-
dards compliance.
D-sub 15 pin Cable
Ferrite core can be used to reduce the elec-
tromagnetic waves that may interfere with the
Ferrite Core
TV. Install the Ferrite core on the power cable
(Black)
close to the wall plug.
(This feature is not
available for all
models.)
Power Cord
x 2
Cable Holder
close to the wall plug.
9