Publicidad
Idiomas disponibles
Idiomas disponibles
EN
62
•
P1-P36 are preset programs. Only the time can be set here. Press
the [+] or [-] button to change the value. The time can be set between
5-99 minutes. The default setting is 30:00 minutes. Press the „MODE"
button to return to the default settings.
•
When you have set everything, press START. The display starts a
5-second countdown and then emits 5 tones. The treadmill starts
slowly and then continuously increases the speed until the preset or
entered speed is reached.
•
While running, press the [+] or [-] button or one of the speed buttons
to set the desired speed.
Note: In the P1-P36 programs, speed and gradient are divided into 10
segments. Each segment lasts the same length. The adjusted speed is
only available in the current segment. 3 seconds before the program
moves to the next segment, a 3-fold signal tone sounds. When the 10
segments are finished, the motor stops and a signal sounds.
•
When running, press the START button to stop the treadmill. Press
START again to continue running. The recording data is retained.
•
Press the STOP button while running, the treadmill stops slowly and
returns to its initial state.
Note: You can remove the safety key at any time to stop the treadmill.
The display then shows the error message [E7] and a warning signal
sounds.
•
The control panel is constantly monitored. If faults occur, an error
message appears on the display and a SIgnal signal sounds.
Publicidad
