Publicidad
Idiomas disponibles
Idiomas disponibles
OPTIONAL ICE-MAKER OPERATION
CAUTION
!
The water supply to the ice-maker must be turned on prior
to turning the ice-maker on. Failure to do so will cause
rapid dry cycling of the ice-maker mold heater resulting in
temperature control issues in the freezer compartment.
Ice-maker operation
•
The unit must be installed level for proper ice-maker
operation.
•
The shutoff arm wire must be down in its lowest posi-
tion for the ice-maker to operate. (See Figure 8).
•
When the freezer section and ice-maker unit has suf-
ficiently cooled, the ice-maker will harvest ice cubes
automatically.
•
When the ice bucket is full, the ice-maker will automati-
cally shut off.
•
You may manually stop the ice-maker by raising the
shut off arm to the locking position at the up most posi-
tion. (See Figure 8).
NOTE
It is recommended the ice-maker is shut off when remov-
ing the bucket, or ice may be dispensed onto the freezer
compartment floor.
If the ice is not used regularly, it will clump together with
time. For best ice results, discard ice in the bin as required
and allow the ice-maker to make a new fresh batch of ice.
Shut-off the ice-maker by raising the shut-off arm before
removing the bucket.
Arm down, ice-maker
will operate
Arm up, stops operation
CARE AND USE/INSTALLATION
Figure 8
7
Publicidad
