Lenco SCD-550SI Manual Del Usuario página 10

you can receive wirelessly a bluetooth sound signal from an external source like a smartphone.
8. AUX IN
This allows you to connect an external player's sound through your unit.
Plug a 3.5mm audio cable (not included) into your external player's line out and the other end into the AUX IN jack at
1.
the rear of the unit.
2. The unit will automatically enter AUX mode.
3. Start your external player to play music. The unit will output the sound.
4. To return to another mode, disconnect the audio cable from the unit.
9. LED LIGHT SHOW
The LED LIGHT SHOW at the speaker of the unit is created automatically based on the music source being played.
1. To turn on the LED LIGHT SHOW slide the LIGHT switch to the ON position.
2. To turn off the LED LIGHT SHOW slide the LIGHT switch to the OFF position.
Note:
- If the brightness is too high, turn on the room lights or turn off the LED LIGHT SHOW.
10