Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble your Slimline II Rack
Refer to SLIMLINE
Fit the LEGS
Refer to LEG ASSEMBLY INSTRUCTION Document LASS1UNI )
(
)
With your Rack in the upside down position (Product sticker should be upside down), fit the Legs to your
A
Slimline II Tray as illustrated below.
NOTE: DO NOT SLIDE THE RACK AND LEGS ACROSS THE ROOF! If there is a chance that you are going to
set the roof rack on to the roof, place some moving blankets and/or towels over the roof. If you must
lower the rack before it is in position, carefully set the Feet on the padded surface.
Once your Slimline II Roof Rack is fitted, ensure a 15mm clearance is maintained between the Wind
Deflector and the vehicles roof otherwise damage to the roof may occur. Bend the Wind Deflector by hand
if necessary.
REV_A01
II TRAY UNIVERSAL ASSEMBLY INSTRUCTION Document RRSTUNI )
(
(
2
Publicidad
