Publicidad
Idiomas disponibles
Idiomas disponibles
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch lever to light up the lamp. The lamp
keeps on lighting while the switch lever is being pulled.
The light automatically goes out approximately 10 sec-
onds after the switch lever is released.
► 1. Switch lever 2. Lamp
NOTICE:
When the tool is overheated, the lamp
blinks. Cool down the tool fully before operating the
tool again.
NOTICE:
Use a dry cloth to wipe the dirt off the lens
of the lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Reversing lever action
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing lever only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
This tool has a reversing lever to change the direction of
rotation. Turn the reversing lever to the A side for clock-
wise rotation or to the B side for counterclockwise rotation.
Make sure that the reversing lever is fully turned with a click.
A
► 1. Reversing lever
All manuals and user guides at all-guides.com
1
2
B
1
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing socket
adaptor
To install the socket adaptor, push it into the adaptor
hole until it locks into place.
1
2
► 1. Socket adaptor 2. Adaptor hole
To remove the socket adaptor, insert a stick like a
screwdriver into the backside of the socket adaptor, and
then tap it gently.
1
2
► 1. Socket adaptor 2. Screwdriver
NOTICE:
During removal procedure, keep holding
the socket adaptor to prevent it from falling off from
the tool.
7 ENGLISH
Publicidad
