Kohler K-5401-0 Guia De Instalacion página 4

Cover Plate
1. Confirm Water Flow Rate
Turn off the water supply.
Remove the existing supply stop and hose.
Install the supply pipe at the location shown in the "Prepare the Site" section.
Slide the cover plate onto the supply pipe.
Apply thread sealant to the supply pipe end (1/2" NPT male).
Thread the supply stop (1/2" NPT female) onto the wall at the water supply.
Direct the supply hose end into a 3 gal (11.4 l) or larger bucket.
Make sure that the supply stop can provide a minimum of 1.5 gal (5.7 l) or more in 10 seconds.
Shut off the water supply.
Disconnect the previously installed supply hose.
1226974-2-E 4 Kohler Co.