Homelite RY43160A Manual Del Operador página 11

CORD
CONNECTING THE POLES
See Figure 3.
Before using the pole saw, a one-time assembly is
required. When removed from the box, the three
poles are connected by an electrical cord as shown
above.
 Remove the four (4) rubber cord protectors
from inside the poles. This material protects the
cord during shipping and MUST be discarded
immediately.
 Unscrew the lower collar from the threaded base
on the intermediate pole and push back over the
cord to the handle pole shaft as shown.
 Insert the handle pole into the intermediate pole
and slide together until you hear the button click.
The tubes are egg-shaped and will only install
one way.
ASSEMBLY
HANDLE
POLE
THREADED BASE
INTERMEDIATE
BUTTON
UPPER
COLLAR
Page 11 — English
LOWER
COLLAR
BUTTON
POLE
POWERHEAD
POLE
 Lower the collar on the handle pole to the
threaded base on the intermediate pole and
rotate clockwise to secure.
 Repeat this process to attach the intermediate
pole to the powerhead pole.
NOTE: Once assembled correctly, handle pole and
powerhead pole should not be able to separate
from intermediate pole when pulled. Repeat above
steps if poles can be separated from intermediate
pole.
WARNING:
Failure to lock powerhead pole as directed
above could result in serious injury or death.
THREADED
BASE
Fig. 3