Publicidad
Idiomas disponibles
Idiomas disponibles
14 • ENGLISH
making any adjustments, changing accessories,
or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power
tool. Power tools are dangerous in the hands
of untrained users.
e. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts and
any other condition that may affect the power
tools operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
5. Battery tool use and care
a. Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
b. Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
c. When battery pack is not in use, keep it away
from other metal objects, like paper clips, coins,
keys, nails, screws, or other small metal objects,
that can make a connection from one terminal
to another. Shorting the battery terminals together
may cause burns or a fire.
d. Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
6. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
7. Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
BLACK+DECKER Service Center or an equally
qualified person in order to avoid damage or
injury. If the power cord is replaced by an equally
qualified person, but not authorized by BLACK+DECKER,
the warranty will not be valid.
8. Labels on tool
The label on your tool may include the following symbols:
Hz .......
Read
Instructions
W ........
Manual
min .....
Use Eye
Protection
.....
Use Ear
Protection
.....
V ........
Volts
n
.......
0
A ........
Amperes
FEATURES (Fig. A)
1. 17 torque positions
2. Rotation direction button (tighten/loosen)
3. Variable speed trigger
4. Quick-change chuck
5. Battery ejector button
SAFETY INSTRUCTIONS AND WARNINGS
CHARGING
1. This manual contains important safety and operating
instructions.
2. Before using battery charger, read all instructions and
cautionary markings on (1) battery charger, (2)
battery, and (3) product using battery.
Caution! To reduce the risk of injury, charge only
BLACK+DECKER Power Packs. Other types of batteries
may burst causing personal injury and damage.
3. Do not expose charger to rain or snow.
4. Use of an attachment not recommended or sold by
BLACK+DECKER may result in a risk of fire, electric
shock or injury to persons.
5. To reduce risk of damage to electric plug and cord,
pull by plug rather than cord when disconnecting
charger.
6. Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or
stress.
7. An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could
result in a risk of fire, electric shock or electrocution.
a.
Two-wire cords can be used with 2-wire or 3-wire
extension cords. Only round jacketed extension
cords should be used, and we recommend that
they be listed by Underwriters Laboratories
(U.L.). If the extension is to be used outside, the
Hertz
...... Class II
Construction
Watts
....
Earthing
minutes
Terminal
Alternating
....
Safety Alert
Current
Symbol
Direct
.../min..
Revolutions
Current
or Recipro-
cation per
minute
No-Load
Speed
Publicidad
