Publicidad
Idiomas disponibles
Idiomas disponibles
• To change the oil, remove the disk, lower
the saw to the lowest position and then
place the tray by the drain outlet (L) [
4].
FIG.
Store in a safe place, out of
reach of children
Maintain tools carefully
AIR FILTER
• Read engine owners manual for
maintenance intervals. For extremely
dusty conditions you may have to clean
the air filter element 2 to 3 times a day.
• Replace any damaged filters or gaskets.
Store in a safe place out ot reach
of children.
Remove all adjustment tools and
wrenches
Store diamond tool in a safe
place so it cannot be bent or
damaged.
11
Engine belt tension
It may be necessary after using a few times
to retension the belts, without over-
tightening them. To do this :
loosen the 4 nuts (S) fixing the motor to
•
the chassis, without removing them
[
5];
SEE FIG.
tighten the nut on the tensioning screw
•
(N); this screw pulls the motor
backwards;
at normal tension, tighten the motor
•
fixing nuts (S).
12
Important advice
SEE
• Periodically, tighten the nuts and bolts
and particularly after the first few hours of
use.
• Check belt tensions, tighten them without
overdoing it.
• When garaged, it is recommended the
disc be removed and suitably stored.
• Make sure the disc is correctly tightened.
• Make sure the disc supports surfaces, the
adaptor plates and the spindle are kept
clean.
The manufacturer declines all
responsibility for loss or damage
resulting from misuse or any
modification,
powering that does not conform
to the manufacturer's original
specifications.
At the work station, the sound
pressure level may exceed
85xdbx(A)
In this case individual protection
measures must be taken.
When working in a limited or
closed area, make sure that the
ventilation is adequate. The
exhaust gases contain carbon
monoxide (exposure to this toxic
gas
can
consciousness and can be fatal).
13
S
A
V
14
For quick supply of spare parts and to
avoid any lost time it is essential to quote
the data on the manufacturer's plate fixed
to the machine and the part number of the
alteration
or
part to be replaced with every order.
Item number
15
cause
loss
of
• Main materials :
Motor : Aluminium (AL), Steel (AC),
•
Motor :
Machine : Steel sheet (AC),
•
Machine :
Machine :
The instructions for use and spare parts
found in this document are for information
only and are not binding.
As part of our product quality improvement
policy, we reserve the right to make any
and all technical modifications without prior
notice.
Repairs
We carry out all repairs in the
shortest possible time and at the
most economical prices (see
overleaf for our address).
Spare parts
00000000
(0)
Quantity
See exploded view
Scrapping
In the event of deterioration and
scrapping of the machine, the
following
items
must
disposed of in accordance with
the
requirements
of
legislation in force.
Copper (CU), Polyamide (PA)
Cast iron (FT)
Aluminium (AL)
be
the
12
Publicidad
