Appendix ：Changing Bios Settings - Sharp PN-ZB03PC Manual De Instrucciones

Appendix：Change BIOS Settings
When setting the BIOS, connect the USB
keyboard (commercially available) to the
mini OPS PC controller board beforehand,
then connect the mini OPS PC controller
board power.
Please turn on the power source.
Please note
• Do not change BIOS settings other than
those described here.
1. Press the [Delete] key on the keyboard
immediately after turning on the power.
The BIOS setting screen will be displayed.
2. Set the item "BIOS setting" on the right.
3. To end the BIOS setting, select [Save & Exit]
- [Save Changes and Reset] and select [Yes]
on the displayed screen.
The BIOS setup screen will be exited and
the mini OPS PC Controller board will
start up again.
■ BIOS settings
Wake system from S5
Select [Advance] - [S5 RTC Wake Settings] -
[Wake system from S5].
To start the mini OPS PC Controller board at
regular time, set it to "Fixed Time". If set to
"Disabled", you can restore the factory default
settings.
When this setting is set to "Fixed Time", the
following items are displayed.
・Wake up hour
・Wake up minute
・Wake up second
"Wake up hour", "Wake up minute", "Wake
up second" sets the hour, minute, second to
be activated.
Example: Confi guring the PC Controller to
start every day at 8:00 in the morning
「Wake system with Fixed Time」
「Wake up hour」
「Wake up minute」
「Wake up second」
Setting value
0-23
0-59
0-59
：Fixed Time
：8
：0
：0
9