Descargar Imprimir esta página

LG LCE3610SB Manual Del Propietário página 25

Ocultar thumbs Ver también para LCE3610SB:

Publicidad

Idiomas disponibles

Idiomas disponibles

eLectricaL connectionS
ELECTRICAL CONNECTION
Connect the flexible armored cable that extends
from the surface unit to the junction box using a
suitable strain relief at the point the armored
cable enters the junction box. Then make the
electrical connection as follows.
Electrical ground is required on this
appliance.
This appliance is manufactured with a supply
wire and a frame connected green or bare
copper grounding wire.
NOTE TO ELECTRICIAN:
The armored cable leads supplied with the
appliance are UL-listed for connection to larger
gauge household wiring. The insulation of the
leads is rated at temperatures much higher than
the temperature rating of household wiring. The
current-carrying capacity of the conductor wire is
governed by the temperature rating of the
insulation around the wire, rather than the wire
gauge alone.
WHERE LOCAL CODES PERMIT CONNECTING THE APPLIANCE-
GROUNDING CONDUCTOR TO THE NEUTRAL (WHITE) WIRE
Observe all governing codes and local
ordinances.
Disconnect the power supply.
1
At the circuit breaker box, fuse box or
2
junction box, connect appliance and power
supply cable wires as shown.
WARNING
You may not ground the cooktop through
the neutral (white) wire if cooktop is used
in a new branch circuit installation (1996
NEC), mobile home, recreational vehicle, or
where local codes do not permit grounding
to the neutral (white) wire. When grounding
to the neutral (white) wire is prohibited,
you must use a 4-wire power supply cable.
Failure to heed this warning may result in
electrocution or other serious personal
injury.
I N S TA L L AT I O N I N S T RU C T I O N S
(cont.)
WARNING
DO NOT ground to a gas supply pipe. DO
NOT connect to electrical power supply
until appliance is permanently grounded.
Connect the ground wire before turning on
the power.
WARNING
This appliance is equipped with a copper
conductor flexible cable. If connection is
made to aluminum house wiring, use only
special connectors which are approved
for joining copper and aluminum wires in
accordance with the National Electrical
Code and local codes and ordinances.
Improper connection of aluminum house
wiring to copper leads can result in a
short circuit or fire. Follow the connector
manufacturer's recommended procedure
closely.
3-WIRE GROUNDED JUNCTION BOX
White wire
(neutral)
Red
wires
Green wire (ground)
Cable from power supply
Junction box
UL-listed conduit
connector
Cable from cooktop
Black
wires
25

Publicidad

loading

Este manual también es adecuado para:

Lce3010sbLce3010sbsp