Oursson CH3030 Manual De Instrucciones página 10

ELEMENTS OF DESIGN, Рiс. C
Pin for setting knives
Power buttons. Use the button to turn on the
cooking process.
UTILIZATION
Before first use, wipe the body
the bowl , lid and knives
some detergents. Dry. Wipe with clean dry cloth. Before
assembling and disassembling the device, make sure
it is unplugged.
ORDER OF OPERATION, Рiс. D
1. Install the ring 3 under bowl's lid and the ring 6 under
the glass bowl, Pic. D-1.
2. Carefully, holding the plastic base, install the upper
knife on the lower one and turn it counterclockwise.
Holding the plastic part, install the knives into the
glass bowl, Pic. D-2.
3. Prepare the necessary ingredients and place them
into the chopping bowl, Pic. D-3.
4. Place the lid on the bowl, Pic. D-4.
RECOMMENDATION ON PREPARATION
• Before chopping, it is recommended to cut ingredients into 2x2x2 cm cubes. The maximum amount of ingredients in the
table is shown for information purposes only. The recommended chopping duration - from 10 to 30 seconds. You can
increase or decrease the chopping time if you want.
Maximum amount of
Product name
the product
300 g
Onion
300 g
Garlic
Bread Croutons 180 g
250 g
Nuts
Hard Cheese 250 g
600-700 g
Meat
Chocolate 200 g
Fruits/Vegetables 300 g
Parsley 80 g
CLEANING AND MAINTENANCE, Рiс. E
Clean all the parts of the device immediately
after use.
• Unplug the device. Remove the motor unit. Open the
bowl's lid. Carefully remove the knives, holding the
plastic part. Disassemble the knives by turning the
upper knife clockwise, and then remove him from the
lower one.
POSSIBLE PROBLEMS AND SOLUTIONS
Possible problems Possible causes
The device isn't turning
No voltage in the socket
on
The device stopped
Motor overheating
during operation
10
with a dry cloth. Wash
in a worm water with
Time, sec.
15 sec.
10 sec.
10 sec.
30 sec.
15 sec.
15-25 sec.
10 sec.
15 sec.
20 sec.
Solutions
• Unplug the device and wait until the voltage recovers.
• Maximum time of continued use of the device – 30 seconds.
5. Place the motor unit into the lid's opening. Make sure it
is set straight, Pic. D-5.
6. Plug in the device.
7. Slightly press the motor unit to lock it properly, and hold
it during the device's operation. Press
and hold it during chopping, Pic. D-6.
8. After chopping, unplug the device. After that, you can
disassemble the device.
Maximum time of continued use of the device
– 30 seconds. The interval between the cycles
should be 10 minutes.
Do not chop ingredients whose temperature is
above 80 °C. Let them cool.
The amount of ingredients must not exceed
"Max" mark.
Note
Cut the onions beforehand on 4 parts.
Remove the shell.
Cut into 2x2x2 cm cubes.
Remove bones, fat, tendon. Cut into 2x5x2 cm cubes.
Remove the pits.
• Wash the lid , bowl and knives
soapy water. They can be washed in a dishwasher.
The water in the dishwasher must not be higher
o
than 60 C.
• Wipe the motor unit with damp soft cloth.
• Never immerse the motor unit in water due to
the risk of electric shock.
• Thoroughly dry all the parts after cleaning.
button
or
in a warm