Publicidad
Idiomas disponibles
Idiomas disponibles
Cuidado y limpieza
Este aparato no contiene piezas reparables por el consumidor. Para servicio,
acuda a personal de asistencia calificado.
LIMPIEZA DE LAS SUPERFICIES EXTERIORES
1. Asegúrese que la plancha se encuentre desconectada y que se haya enfriado
completamente. Limpie la suela y demás superficies exteriores con un paño
suave humedecido con agua y con un detergente suave. Nunca utilice
abrasivos, limpiadores fuertes, vinagre ni esponjas abrasivas que pudiesen
rallar o descolorar la plancha.
2. Después de limpiar la plancha, pase la planche a vapor sobre un paño viejo
para eliminar cualquier residuo acumulado.
ALMACENAJE DE LA PLANCHA
1. Desconecte y permita que la plancha se enfríe bien.
2. Asegúrese que el selector se encuentre ajustado a la posición min.
3. Coloque la plancha verticalmente sobre el talón de descanso para evitar que
la suela gotee.
5
IMPORTANT SAFETY
INSTRUCTIONS
When using your iron, basic safety precautions should always be followed,
including the following:
❑ Read all instructions before using.
❑ Use iron only for its intended use.
❑ To protect against a risk of electric shock, do not immerse the iron in water
or other liquid.
❑ The iron should always be turned to off (refer to "How to Use" section) before
plugging into or unplugging from an outlet. Never yank cord to disconnect
from outlet; instead grasp plug and pull to disconnect.
❑ Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around iron when storing.
❑ Always disconnect iron from electrical outlet when filling with or emptying
of water, and when not in use.
❑ Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble the iron,
take it to a qualified serviceman for examination and repair. Or, call the
appropriate toll-free number listed on the cover of this manual. Incorrect
reassembly can cause a risk of electric shock when the iron is used.
❑ Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board.
❑ Burns can occur from touching hot metal parts, hot water, or steam. Use
caution when you turn a steam iron upside down or use the surge of
steam — there may be hot water in the water tank. Avoid rapid
movement of iron to minimize hot water spillage.
SPECIAL INSTRUCTIONS
❑ To avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
❑ If an extension cord is absolutely necessary, a 15-ampere and 120-volt,
or 7-ampere and 220-volt cord should be used. Cords rated for less
amperage may overheat. Care should be taken to arrange the cord so that
it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS.
6
Publicidad
