LG LT1016CER Manual Del Propietário página 18

Operating Instructions
Operating Instructions
POWER
Operation starts when this button is pressed and stops when you
press the button again.
FAN SPEED SELECTOR
Use to set the fan speed to Low (F1), MED (F2), High (F3).
ON/OFF TIMER
Delay ON - when the air conditioner is off, it can be set to automatically turn
on from 1 to 24 hours at its previous mode and fan settings.
Delay OFF - when the air conditioner is on, it can be set to automatically turn
off from 1 to 24 hours.
OPERATION MODE SELECTOR
Push the MODE button to rotate between Energy Saver / Cool / Fan / Dry.
Energy Saver
Approximately every 3 minutes the fan will turn on and check the room air
temperature if cooling is needed.
Compressor runs and cools the room. Use the
Cool -
to set the desired temperature and circulation fan speed.
Fan
- Fan circulates air but compressor does not run. Use the FAN button to set
the desired fan speed.
Dry - Dry mode is used to remove humidity from the room without additional cooling.
Once the set temperature is reached， the compressor and circulation fan turns off.
Fan speed is pre-set and cannot be adjusted.
18 Room Air Conditioner
7
The fan stops when the compressor stops cooling.
-
REMOTE CONTROLLER
Temp
Fan Speed
Timer Mode
and FAN buttons