POWER CELL & CHARGER SAFETY
Use the charger only in a standard 120
V AC, 60 Hz electrical outlet.
WARNING:
the charger in wet or damp
conditions. The charger is intended for
indoor use only. Do not use outdoors.
Do not expose to dew, rain or garden
sprinklers, frost, or snow. Do not use
the charger near sinks or tubs. Do not
immerse the charger in water. Water
entering the chargers or Power Cells will
increase the risk of electric shock.
Do not operate the charger in
explosive atmospheres, such as in
the presence of flammable liquids,
gases or dust. Chargers can create
sparks which may ignite the liquids,
fumes or dust.
Do not use the CRC8000 rapid charger
to charge any batteries other than a
CFC6500 Power Cell. Charging other
batteries may cause the batteries to
burst, catch fire, emit hazardous fumes
or explode.
Do not allow the charger cord to hang
over the edge of a table or counter, to
be placed in an area where it can
become entangled with moving objects,
or be a tripping hazard, or to contact
sharp or hot surfaces. The charger
should be placed away from sinks and
hot surfaces.
Do not leave a Power Cell on a
prolonged charge. Remove the Power
Cell after attaining a complete recharge
and unplug the charger when not in
further use.
INSTRUCTIONS
Do not use
13
Do not operate the charger if the cord or
plug is damaged. Have a qualified
technician replace the damaged cord
and plug immediately.
Do not operate the charger if it has
received a sharp blow, been dropped,
crushed, cracked, punctured, immersed
or splashed with water or other liquids,
or otherwise damaged in any way. Have
a qualified technician examine the
charger and repair it if necessary. Do
not disassemble or modify the charger.
WARNING:
plugged into the power supply, it can
become shorted by foreign conductive
material and cause sparks or fires.
Foreign conductive material such as, but
not limited to, metal shavings / chips,
steel wool, aluminum foil, nails, staples,
paper clips, should be kept away from
charger ventilation openings, Power Cell
retaining cavity and output terminals.
Do NOT charge the Power Cell when
the work area or the Power Cell
temperature is at or below 0° C (32° F)
or above 45° C (113° F).
Unplug the charger when it is not in use
and before cleaning or maintenance.
POWER CELL RECYCLING
To preserve our natural resources, and
reduce landfill please recycle your
Power Cells at participating retailers, or
dispose of Power Cells properly in
accordance with Federal, State,
Provincial or local laws.
Refer to the Maintenance section for
additional Power Cell recycling
information.
When the charger is