Blender Safety
IMPORTANT: This operation manual should be reviewed with all equipment operators as part of your
operator training program.
IMPORTANT SAFETY INSTRUCTIONS
WARNING –
When using electrical appliances, basic safety precautions should be followed,
including the following:
1. Read the Operation Manual before using blender.
Keep Operation Manual handy.
2. Plug into a grounded 3-prong outlet.
3. Do not remove ground prong.
4. Do not use an adapter.
5. Do not use an extension cord.
6. Disconnect power before cleaning or servicing.
7. To reduce risk of personal injury, unplug cord from
outlet when not in use, and before putting on or
taking off parts.
8. To protect against electrical shock, do not immerse
cord, plug, or blender base in water or any other
liquid.
9. Do not spray the base with a high-pressure spray gun.
10. Extreme caution must be used when moving an
appliance containing hot oil or other hot liquids.
11. Do not use appliance for other than intended use.
12. Not intended for use by or near children.
13. The appliance is not intended for use by persons
(including children) with reduced physical, sensory, or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
14. Children should be supervised to ensure that they do
not play with the appliance.
15. The use of accessory attachments not recommended
by the appliance manufacturer may cause injuries.
16. To reduce risk of personal injury and to prevent
damage to blender or container and cutter assembly,
DO NOT insert utensils into blender container while
operating blender.
17. Do not store any kitchen utensils in the container
because the blender would be damaged if
inadvertently turned on.
2
All manuals and user guides at all-guides.com
SAVE THESE IN STRUC TIONS
–
18. To prevent possibility of serious personal injury, keep
hands out of blender container while operating blender.
Always operate blender with container lid in place.
19. Avoid contacting moving parts.
20. Blades are sharp. Handle carefully.
21. If cutter assembly blades are loose, discontinue use
immediately and replace cutter assembly. Do not
attempt to repair or tighten cutter assembly.
22. Inspect container and cutter assembly daily. Do not
use broken, chipped or cracked container. Check
cutter for wear, nicks, or broken blades. Do not use
broken or cracked cutting blades.
23. Do not use outdoors.
24. This appliance is intended for short periods of
operation, with a rated operating time of 3 minutes.
25. Do not leave blender unattended while it is operating.
26. To prevent damage to blender, container, or cutter
assembly, DO NOT move or shake blender while in
operation.
27. When blending hot liquids, remove center-piece of
two-piece lid. Hot liquids may push lid off container
during blending. To prevent possible burns: Do not fill
blender container beyond the 32 oz. (1 liter) level. With
the protection of an oven mitt or thick towel, place one
hand on top of lid. Keep exposed skin away from lid.
Start blending at lowest speed.
28. Always operate blender with container lid in place.
29. Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions, or is dropped
or damaged in any manner. Call the Technical Services
number, 866-285-1087 or 910-693-4277, for
instructions on examination, repair, or electrical
or mechanical adjustment.
–