Echo SRM-301TES Manual De Instrucciones página 12

Before you start
Loop handle version
Loop handle assembly
U-handle version
U-handle assembly
Installation of shield
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
E: Arrow
 Install the handle to the engine side from the arrow
mark.
1. Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (B) and fix handle by tightening
handle assembling bolt (C) lightly.
2. Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
 To adjust the fixture bolt (D) proceed (As needed)
(1) Tighten the bolts until snug.
(2) Loosen the bolts 1
E: Arrow
F: To engine
 Install the handle to the engine side from the arrow
mark.
3. To eliminate loosening of throttle wire (I), fix it to shaft tube
(H) (2 places) and to right hand U-handle (1 place) with wire
fixing clips (G).
1. Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
10
F: To engine
CAUTION
1
/ turn.
2
CAUTION