Attaching The Front Handle; Operation - Echo CPH-58V Manual Del Operador

ASSEMBLY
This 58 V power head may be used with only the following
ECHO attachment:
 SSA-58V Straight Shaft String Trimmer
The attachment connects to the power head by means of
a coupler device.
 Stop the motor and remove the battery pack.
 Loosen the knob on the coupler of the power head shaft
and remove the end cap from the attachment.
 Pull the retaining pin located on the power head shaft and
rotate 1/4 turn. Rotating allows the pin to lock out of the
shaft even when released.
 Align the hole in the attachment shaft with the retaining
pin on the power head shaft and slide the two shafts
together.
 Rotate the retaining pin 1/4 turn to allow the pin to fully
seat through the hole in the attachment shaft.
NOTE: If the pin does not release completely in the posi-
tioning hole, the shafts are not locked into place. Slightly
rotate from side to side until the pin is locked into place.
 Tighten the knob securely.
WARNING
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious personal injury.

OPERATION

WARNING
Read and understand entire Operator's Manual for
each optional attachment used on this power head and
follow all warnings and instructions. Failure to follow
all instructions could result in electric shock, fire and/
or serious personal injury.
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Hearing and/or head
protection may also be required depending on the
type of attachment used and as prescribed in the
attachment's Operator's Manual. Failure to do so could
result in objects being thrown into your eyes and other
possible serious injuries.
Removing the Attachment From the Power
Head
See Figure 2.
 Stop the motor and remove the battery pack.
 Loosen the knob.
 Pull the retaining pin and twist the shafts to remove and
separate ends.

Attaching the Front Handle

See Figure 3.
 Remove the bolts, flat washers, and lock washers from
the front handle.
 Install the handle between the arrow and the connector
on the upper end of the tool.
NOTE: When properly installed, the front handle will angle
toward the operator.
 Adjust handle up or down, if necessary, to desired
operating position.
NOTE: The front handle should always be placed beyond
the arrow. This is the minimum acceptable distance
between the front and rear handle.
 Reinstall the washers and bolts; tighten securely.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
Before each use, inspect the entire product for
damaged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or a qualified service center for assistance.
This product will accept ECHO 58 V lithium-ion battery
packs only.
For complete charging instructions, refer to the Operator's
Manuals for your ECHO battery pack and charger models.
English
WARNING
NOTICE
7