Publicidad
Idiomas disponibles
Idiomas disponibles
BULB REPLACEMENT
IMPORTANT
● The bulb must be replaced by the manufacturer, its service agent or similarly qualified persons.
● Always switch off the electricity supply before carrying out any operations on the appliance. When
handling bulb, make sure it is completely cool down before any direct contact to hands.
● When handling globes hold with a cloth or gloves to ensure perspiration does not come in contact
with the globe as this can reduce the life of the globe.
Changing the light
● Use the screw driver loosen the ST4*8MM self tapping screw (2pcs) from the lighting panel, take out
the lighting fixture. Open the terminal box that connected with the wire, disconnect the wire connector
and replace the lamp.
Note: It must be sure that the power supply is completely cut off before the above operation.
● ILCOS D code for this lamp is: DBS-2/65-H-120/33
» LED modules –rectangle lamp
» Max wattage: 1×2 W
» Voltage range: AC 110-240V
» Dimensions:
120 mm
[ EN ● 15 ]
Version: 3:0
KEN002DH 24.02.2021
Publicidad
