Descargar Imprimir esta página

Danby DWM12C1WDB Manual Del Propietário página 7

Ocultar thumbs Ver también para DWM12C1WDB:

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
CONTROL PANEL
1. Procedure button: Press to select the steps included in the wash cycle. The light will illuminate to show
which steps are active. Normally all steps are included and all lights will be on: soak, wash, rinse and
spin.
2. Display panel: The display will show the estimated minutes remaining in the current cycle. If delay
start is set, the display will count down the time until the cycle begins and then change to showing the
remaining minutes in the cycle once the program begins.
3. Delay start button: Press to set the desired time before the wash program begins.
4. Load size button: Press to set the wash load size. This setting will decide the water level. The light will
illuminate to show which level is active.
5. Temperature button: Press to set the water temperature. The light will illuminate to show which
temperature setting is active. Note that the temperature is for the wash cycle only. All rinse cycles are
completed with cold water.
6. Control lock: Press and hold the temperature button and the program button at the same time for 3
seconds to set the control panel lock. Buttons on the control panel cannot be pressed while the lock is
active. Press and hold the temperature button and the program button at the same time for 3 seconds to
clear the control panel lock.
7. Program button: Press to select the desired wash program, normal, heavy, delicate, quick, bulky or spin
only. The light will illuminate to show which program is active.
8. Extra rinse button: Press to add an extra rinse cycle to the wash program.
9. Start/Pause button: Press to start a chose wash program. Press during operation to pause a wash cycle
while it is running. Press again to continue the cycle.
10. Power button: Press this button to turn the appliance on or off.
PROCEDURE
SOAK
WASH
RINSE
SPIN
1
PROCEDURE
DELAY (HR)
2
TIME (MIN)
DELAY
3
4
5
DELAY
LOAD SIZE
LIGHT
FLASH
HOT
NORMAL
QUICK
WARM
HEAVY
BULKY
DELICATE
SPIN ONLY
COLD
7
CONTROL LOCK
6
TEMP
PROGRAM
6
9
START/PAUSE
8
EXTRA RINSE
10
ON/OFF

Publicidad

loading