Publicidad
Idiomas disponibles
Idiomas disponibles
840175602 ENv04.qxd:840152100 Ev01
To heat water
Use heated water to make instant coffee, hot cocoa, or tea.
• Remove cover, basket and stem. Fill percolator with cold water to desired level as indicated
by numbered servings on inside of percolator or water window. Do not fill beyond MAX.
• Place basket on stem. Hold top of stem and place stem and basket into heating unit
well. (Using the stem and basket will speed heating time.) Place spreader on basket.
• Push lid down; then turn to lock. The glass portion of the lid will be hot during
operation. WARNING! Burn Hazard. Scalding may occur if the lid is removed
during the brewing cycle. Plug cord into the percolator; then plug the cord into
electrical outlet. The unit automatically turns on.
• The Ready Light will glow when water is ready, and percolator will automatically
go into a keep-warm mode.
Electrical Shock Hazard.
w WARNING
Disconnect power before cleaning.
To reduce the risk of electrical shock, do not immerse the cord, plug
or percolator in water or any other liquid.
How to clean
• After each use, unplug cord from outlet; then remove cord from the percolator. Let
cool before cleaning.
• Remove lid, basket, spreader, and stem. Wash these in hot, soapy water. (These
parts can also be placed in dishwasher.) Do not put percolator in dishwasher.
• Rinse all parts thoroughly and dry. Store with cover off. NOTE: Make sure the washer at
Stem
Washer
• Drain the soapy water; then fill the percolator with hot water to rinse. Pour soapy
water through spout to clean the spout. Repeat with another hot water rinse. Dry.
• Clean outside of percolator with a damp cloth. Do not use abrasive scouring pads
or cleansers.
To remove mineral deposits and buildup
If the percolator is used daily, follow these instructions every other week.
• Fill the percolator with equal parts of cold water and vinegar: Fill to the 6-cup line
with cold water; then add white vinegar until the solution reaches the 12-cup line.
Do not fill beyond the 12-cup line. Assemble with stem, basket, spreader, and lid.
• Plug in and complete one perk cycle. When perking has stopped, let sit another
15 minutes. Unplug and drain percolator. Let cool; then clean according to "How
to clean."
2/15/10
9:09 AM
OPERATION (CONT.)
CARE AND CLEANING
the bottom of the stem remains loose. If coffee grounds lodge
in this area, remove them under running water or with a
wooden pick; then rinse and dry.
• Fill the percolator half-full with hot water. Add a drop of
liquid dishwashing detergent and wash the inside of the
percolator. Use a sponge and clean the inside of the
heating unit well. This part must be properly cleaned to
maintain the proper operation of the percolator. Do not
immerse percolator in water.
Page 5
5
Publicidad
