TFA LUMATIС GUARD Instrucciones De Uso página 2

TFA_No. 43.2033_Anleitung_06/17
LUMATIC GUARD
LED multi-function safety lamp
A: 5-LED-lights (above)
B: 15-LED-lights (in front)
C: ON/OFF button
D: Light sensor
E: IR motion sensor
F: Induction contact for
the charging station
RoHS
A
Thank you for choosing this instrument from TFA.
1. Before you use this product
• Please make sure you read the instruction manual carefully.
• Following and respecting the instructions in your manual will prevent damage to
your instrument and loss of your statutory rights arising from defects due to incor-
rect use.
• We shall not be liable for any damage occurring as a result of not following these
instructions.
• Please take particular note of the safety advice!
• Please keep this instruction manual for future reference.
2. Field of operation and all the benefits of your new instrument at a glance
• Night light with IR motion sensor (15 LEDs)
• Flashlight - always at hand in the right place, at once light without turning on (5 LEDs)
• Automatic emergency lighting during a power outage
• Comfortable charging at the socket (by induction)
• Built-in rechargeable battery
3. For your safety
• The product is exclusively intended for the field of application described above. It
should only be used as described within these instructions.
• Unauthorised repairs, modifications or changes to the product are prohibited.
Caution!
Risk of injury:
• Do not shine directly into the eyes with the flashlight.
• Keep this instrument and the charging station out of the reach of children.
• Protect the flashlight from overheating! Do not leave the flashlight on unattended.
• After removing the flashlight from the charging station, the lower side is heated by
charging. Make sure that the flashlight is cooled off before touching it. Turn off the
flashlight after use.
Risk of burns!
Caution!
Risk of electrocution:
• Plug the charging station only into a socket installed in regulation manner and with a
mains voltage of 230V!
• The mains socket must be installed near the equipment and it must be easily accessible.
• The charging station must not come into contact with water or moisture. Only suitable
for operation in dry interiors.
• Do not use the charging station if the housing or the main adapter is damaged.
• Keep the charging station out of reach of persons (including children) who cannot
fully appreciate the potential risks of handling electrical equipment.
• Pull the charging station out of the socket immediately if any fault occurs or if the
charging station is not used for a lengthy period.
• Only use the supplied charging station for the flashlight.
Important information on product safety!
• Do not place the unit near extreme temperatures, vibrations or shocks.
4. Operation
• Please charge it fully before the first use.
• If the illumination decreases, put the flashlight into the charging station.
4.1 Charging of the LED multi-function safety lamp
• Plug the charging station into a socket.
• For charging put the flashlight with the lower side into the charging station. The 15-
LED lights show to the front.
• For fully charge put the flashlight at least 8 hours in the connected charging station.
• The charging process is completed automatically.
4.2 Use as a LED flashlight
• Take the flashlight out of the charging station.
• When taken out, the 15 LED lights turn on automatically.
• Press the ON/OFF button again, the 15 LED lights turn off and the 5 LED lights (above)
turn on.
• To switch off the flashlight press the ON/OFF button again.
31.05.2017 9:13 Uhr Seite 2
F
E
D
C
B
Operating Instructions
4.3 Use as an infrared motion sensor
• Plug the charging station into a wall outlet. For the best sensor effect the socket
should be located about 1.5 m above the ground.
• Put the flashlight with the 15-LED light forward into the charging station.
• Does the infrared motion sensor detect a movement about 2 to 3 m in front of the
sensor, the 15-LED lights will turn on automatically.
• The flashlight has a light sensor to turn on the light automatically only at dark.
• The flashlight will turn off automatically after a few seconds.
4.4 Use as an emergency light
• By power outage the 15-LED lamps turn on automatically.
5. Waste disposal
Never dispose of empty batteries and rechargeable batteries in household
waste.
As a consumer, you are legally required to take them to your retail store or
to appropriate collection sites depending on national or local regulations in
order to protect the environment.
The symbols for the heavy metals contained are:
Cd=cadmium, Hg=mercury, Pb=lead
This product is labelled in accordance with the EU Waste Electrical and
Electronic Equipment Directive (WEEE).
Please do not dispose of this product in ordinary household waste. As a
consumer, you are required to take end-of-life devices to a designated col-
lection point for the disposal of electrical and electronic equipment, in
order to ensure environmentally-compatible disposal.
6. Specifications
LED lamps
ϕ 5 120°LED / 1200 – 1300 mcd / 0,07 W
5-LED-lights:
ϕ 5 15°LED / 15000 – 17000 mcd / 0,07 W
15-LED-lights:
Range: up to 3 m
Operating time: 5-LED-lights – more than 2 hours
15-LED-lights – more than 1.5 hours
Infrared motion sensor
Distance / angle: 2 – 3 m /60°
≤5µA
Quiescent current:
Illumination time: approx. 20 seconds
Power consumption: Charging station AC 220V / 50HZ / 0.015A
Battery: 052030 Li-ion Battery 3.7 V, 250MAH
Charging time: 8 hours
Dimension: 50 x 35 x 153 mm
Weight: 92 g (instrument only)
TFA Dostmann GmbH & Co.KG
Zum Ottersberg 12, D-97877 Wertheim, Germany
No part of this manual may be reproduced without written consent of TFA Dostmann.
The technical data are correct at the time of going to print and may change without prior
notice.
The latest technical data and information about your product can be found by entering
your product number on our homepage.
www.tfa-dostmann.de
Cat.-No. 43.2033
06/17