Publicidad
Idiomas disponibles
Idiomas disponibles
5. Overview
Refer to the illustrations on page 2 of this manual.
1
protective glass
2
power cable
6. Installation
Guidelines
A qualified technician should install and service this device.
The construction to which the device is attached should be able to
support 4 times the weight of the device for one hour without
deformation.
Never stand directly below the device when it is being mounted, removed
or serviced. Have a qualified technician check the device once a year and
once before you bring it into service.
Overhead mounting requires extensive experience: calculating workload
limits, determining the installation material to be used... Have the
material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation
may result in serious injuries.
Do not fix the device to flammable surfaces.
This device is not suitable for dimming.
Distances
Keep the device at least 20 cm away from ceilings or walls.
Respect a minimum distance of 1 m between the device's light output and
any illuminated surface.
Mounting the Lamp
1. This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
2. Use the mounting bracket [3] to determine the location of the mounting
holes.
3. Drill the holes and secure the bracket using 2 screws and wall plugs (not
incl.).
4. Connect the power cable [2] to a suitable junction box (not incl.). Make
sure the connection is properly earthed. Make sure there is no strain on
the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order to
avoid any hazard.
5. Tilt the lamp in the desired angle.
V. 01 – 08/08/2014
LEDA315/LEDA316/LEDA317
5
3
mounting bracket
4
hinge
©Velleman nv
Publicidad
