HQ-Power HQLE10050 Manual Del Usuario página 11

5.4 Master/Slave Mode
•
The master/slave mode allows for connecting several devices to a single master device in a
daisy chain.
•
All slave devices will then work synchronously with the master device.
•
Configure all slave units before connecting the master unit to the daisy chain.
5.5 DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.
•
All DMX-controlled devices need a digital start address so that the correct device responds
to the signals. This digital start address is the channel number from which the device starts
to "listen" to the DMX controller. The same starting address can be used for a whole group
of devices or an individual address can be set for every device.
• When all devices have the same address, all the units will "listen" to the control signal on
one particular channel. In other words: changing the settings of one channel will affect all
devices simultaneously. If you set individual addresses, each device will "listen" to a
separate channel number. Changing the settings of one channel will only affect the device
in question.
Refer to page 3 of this manual for the DMX channel values.
5.6 Remote Control
Black Out
Press this button to black out the current active mode. Press again to return.
Auto
1. Press <AUTO> to enable the auto mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <AUTO> to disable.
Sound
1. Press <SOUND> to enable the sound mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <SOUND> to disable.
Strobe
1. Press <STROBE> to enable the strobe mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <STROBE> to disable.
Speed
1. Press <SPEED>.
2. Press <+> or <-> to adjust the programme speed.
Sensitivity
1. Press <SENSITIVITY>.
2. Press <+> or <-> to adjust the microphone sensitivity.
DMX/%
Allows you to activate/de-activate the DMX mode.
V. 01 – 06/01/2021
HQLE10050
11 ©Velleman nv