Go Rhino D64029TK Instrucciones De Instalación página 5

INSTALLATION INSTRUCTIONS
STEP # 3
• Slide the screw with plate on the hole. Once located, carefully put the plastic washer on
the screw, this will prevent the screw to move once the bracket is installed.
STEP # 4
• Present the bracket on position. This will allow you to mark an area on the fabric inner
cover that needs to be cut. Once cut, install the bracket using one Hex Nut and one flat
washer. Do not tight the assemble yet.
REV.01
© 2016 Go Rhino Products. All rights reserved
5