Royo kurai Manual De Instalación página 7

Installation Requirements
2. Perform a water drainage test to ensure correct installation. Verify absence of obstructions
and drainage capacity.
3. Apply PU/MS putty or silicone between the tray and the base to attach it.
Apply a silicone bead to the joins of the shower tray with the wall and the floor.
4. Connect the valves to the shower tray.
It is normal for small traces of water to remain as a result of surface tension.
Routine cleaning of the tray will be done with water.
Use a damp sponge with soap for thorough cleaning. Use an anti-limescale product in case
of calcareous sedimentation. Finally, rinse with warm water and leave to dry. If any chemical
product, such as bleach, acetone, hair dye, mercurochrome and so on comes into contact
with the shower tray, remove it immediately with neutral soap and plenty of water and dry
with a damp cloth. Do not use abrasive materials for cleaning.
Protect the tray once it is in place and before tiling (you can use the packaging of the tray to do this)
to avoid traces of cement, plaster or similar falling on the tray.
Our company will not be responsible for deterioration of the shower tray as a result of these
instructions not being followed.
kurai
Silex/Privilege
Avant/Essential
3 mm
5. Fit the decorative cover.
GB
±3mm
3 mm
-07-