Descargar Imprimir esta página

EGAmaster 58901 Manual De Instrucciones página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

5. For loosening a fastener, place the direction switch in reverse. Then, press the trigger on the
pistol grip to loosen the fastener. The unit will continue to rotate until the fastener is removed
OR once the fastener is loose you can remove it by hand and move to next fastener.
6. Continue the process for tightening or loosening for each fastener you require.
7. If torque requirements require your application to go in torque increments, then set Torque
Wrench to your first torque requirement. Tighten fastener as per your required tightening bolt
sequence. Then, reset for the next settings.
8. Your personnel can be trained by your or Distributor on use of this product if so desired.
1. Remove the Torque Wrench from the application.
2. Disconnect the battery to the Torque Wrench.
3. Remove and change the socket or accessory adaptor for the next project. Ensure the socket
or accessory is properly secured to the square drive with a locking pin and safety securing
o-ring.
22
wrong
correct
CHANGING ACCESSORIES
wrong

Publicidad

loading

Este manual también es adecuado para:

58876588775887858875