Maximum Permitted Wind Strength; Table Of Wind Resistance Classes; General Operation - Stobag 222134 Instrucciones De Servicio

Operating instructions
1.3

Maximum permitted wind strength

The sun protection system has been constructed so that the largest size meets the
minimum requirements for wind resistance class 2 in the CE conformity classification
(see table 1.4). Depending on the projection, it may also meet resistance class 3. The
wind resistance class after the system has been installed depends largely on the type and
quantity of fixing materials used and the surface it is installed upon. The sun protection
system may only be used up to the wind resistance class declared by the installer.
1.4

Table of wind resistance classes

Class Wind strength
(Beaufort)
0
1 – 3
1
4
2
5
3
6

2.0 General operation

• There should be no people or obstacles in the way of the sun protection system when it
is being extended or retracted.
• Never let children operate the sun protection system or any control unit.
• The operator must be able to see the sun protection system while operating it.
• The sun protection system must not be used if it needs to be repaired or serviced. Any
control units must be switched to manual operation.
• For manual operation, the shaft of the operating handle must be used in the same
direction as the gearbox ring when extending or retracting the sun protection system.
Do not continue to turn the operating handle when the end position has been reached.
EN-28
| www.stobag.com
Wind speed
Up to 19 km / h
20 – 28 km / h
29 – 38 km / h
39 – 49 km / h
Effect
Leaves and thin twigs are blown
about
Twigs and thin branches bend and
waste paper is raised from the
ground
Branches sway and small bushes
are shaken
Thick branches sway, umbrellas
are difficult to hold
All rights to make modifications are reserved