Magic Chef GCRVMC01 Manual Del Usuario página 5

FILLING WATER TANK
1. Disconnect the iron power cord from electical outlet before
filling the tank.
2. Set the ADJUSTABLE STEAM CONTROL to NO STEAM " "
position so that the water enters directly into the tank and in
order to avoid spillage.
3. To fill the tank, remove fill cap and pour water into water fill
hole.
NOTE: Do not overfill the water tank.
4. The water level can be seen through the water tank. If the iron
needs more water during use, first unplug iron from electrical
outlet, then fill with the iron in a vertical position.
IRONING TIPS
1. Sort items to be ironed according to the temperature settings
they require. Begin ironing at the lower settings and increase
temperature as needed. If in doubt about what temperature to
use for any fabric, start at a low temperature setting and iron
on an inside seam allowance. Gradually increase the heat and
steam settings until wrinkles are removed without damaging
the fabric.
2. When changing from a high temperature setting to a
lower setting allow approximately 5 minutes for the lower
temperature to be reached.
E6
SPRAY FUNCTION
Be sure the iron is filled with water. If fabrics are too dry, or have
stubborn creases or wrinkles, the spray feature can be used to
moisten the area. When the SPRAY BUTTON
the iron is in the horizontal position), a fine spray of water will
emit from SPRAY NOZZLE at front. It may be necessary to push
the SPRAY BUTTON a few times before spray starts.
DRY IRONING
Sort items to be ironed according to the temperature settings
on garment labels. Put the iron in a vertical position, set
the ADJUSTABLE STEAM CONTROL to NO STEAM " " and
TEMPERATURE CONTROL DIAL in a level suitable for the garments.
Begin ironing with garments that require a lower settings
(synthetic fabrics and silk) and gradually increase heat to iron
garments that require higher temperatures.
When changing from a high temperature setting to a lower setting,
allow approximately 5 minutes for the lower temperature to be reached.
STEAM IRONING
Plug in the iron after filling the water tank, set the ADJUSTABLE
STEAM CONTROL to desired amount of steam, according to the
desired temperature. Put the iron in a vertical position, after
the temperature indicator light has turned off, press the steam
button.
is pressed (while
E7