Pioneer DVR-A04 Manual De Instrucciones página 9

INSTALLATION
1 Turn off the power supply of the personal computer, and remove the cover or the
front panel.
2 Remove the blank panel installed on the front of the 5.25 inch slot.
3 Install the fixing slide rails on the drive. (When slide rails are required, please contact
your shop or the computer manufacturer.)
4 Insert the drive into the slot.
5 When fixing is required, please refer to the instruction manual for the computer.
÷ Please use screws with a length of 5 mm (3/16 in.) or less for mounting. Using
longer screws may cause damage on the drive.
÷ When the mounting screws are loose etc., the vibrations from disc rotation may
generate ripping noise, to prevent it the screws should be tightened securely.
USING THE DISC SUPPORT TABS
When installing this writer vertically, two disc support tabs must be used to support a
loaded disc. The unit has been factory shipped with the disc support tabs in their outboard
position, however, where they will not support discs (Position B in the illustration).
÷ When this unit is installed vertically, release the two disc support tab locks and move the
tabs to their inboard positions (Position A). To load a disc, insert the disc in the specified
loading position in the tray so that it is supported between the tabs.
÷ When this unit is installed horizontally, leave the disc support tabs in their outboard positions
(Position B). To load a disc, merely place the disc label-side up in the specified position on
the disc tray.
* When loading a disc, the two disc support tabs must be set in the proper position.
Precautions on playing 8 cm (3.15") Discs
An 8 cm (3.15") disc cannot be played even an adapter is attached to the disc when the drive is
upright condition.
B
A
A
B
Disc Tray
9
En