Bycool blue line FLAT Instrucciones De Montaje página 32

FLAT
ES
EN
1
1- Run the power cable of the equipment to the vehicle battery, sticking the plastic supports on the rear
part of the cab and attaching it with cable ties; then with the cab folded forward pass the cable through
the lower area and fasten it with clamps and M4 screws; and as far as the battery with cable ties; the
same pitch should be used as that of the original cable. (Clean the area well before sticking the plastic
supports). On connecting the equipment to the battery this will automatically carry out a test on all its
leds, and will switch off.
IMPORTANT: Due to the complex electronic regulation of the equipment, the current connection
must be made directly to the vehicle battery, and not to any other point which services other
accessories of the vehicle, taking care not to invert the polarity when making the connection
(2). Inverting the polarity may result in irreparable damage to the electronic control, which is not
covered by the warranty.
IMPORTANT: To start the machine consult the User Manual.
2
Detailed instructions
about power supply installation
+
Power
Cable
2
32
Air conditioning for vehicles
-