Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE BRIGHTNESS OF THE DISPLAY
In the clock time state, repeatedly press SNOOZE/SLEEP/DIMMER
to change the brightness of the display (High, Medium and Low)
according to your ambient light conditions.
USING THE PROJECTOR
The projection function allows you to display the clock on a nearby
wall or ceiling at a range of 0.9-2.7 metres.
1. Press PROJECTION ON/OFF to turn on the projector.
2. Adjust the projector by tilting it to the desired angle for best
viewing.
3. Adjust the focus by turning the focus dial on the projector until the
image is sharp.
Focus dial
4. To flip the projected image horizontally, press PROJECTION
180° FLIP.
5. To turn off the projector, press PROJECTION ON/OFF.
RESTTING THE UNIT
If the system does not respond or exhibit erratic or intermittent
opeartion, you may have experienced an electrostatic discharge
(ESD) or a power surge that triggered the internal microcontroller to
shut down automatically. If this occurs, disconnect the power cord
from the mains socket and remove the backup battery from the unit.
Wait for at least 3 minutes and reinsert the battery for backup, and
plug the unit in the mains socket. The unit is now reset and you will
need to set the clock time and alarm settings again.
SPECIFICATIONS
FM frequency: 87.5-108 MHz
Power source: AC 230V~ 50Hz, 5W
Battery (for clock back up): DC 3V
(1 x 3V CR2032 Lithium
battery, not included)
Direct Current ~ Alternating Current
EN-7
Publicidad
