Hunter 99772 Manual De Instrucciones

CEILING FAN REMOTE CONTROL
Model 99772
HUNTER FAN COMPANY CONTROL LIMITED WARRANTY
The Hunter Fan Company makes the following limited warranty to the original purchaser
of the Control ("Control"): Your Control is warranted to be free from defects in material and
workmanship for a period of one year from the date of sale. If the Control malfunctions or fails
within the warranty period due to a defect in material or workmanship we will replace it free
of charge. IF THE ORIGINAL PURCHASER CEASES TO OWN THE CONTROL, THIS WARRANTY
AND ANY IMPLIED WARRANTY, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE VOIDED. THIS WARRANTY
IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. THE DURATION OF ANY IMPLIED WARRANTY,
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, IN RESPECT TO ANY CONTROL, IS EXPRESSLY LIMITED TO THE
PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE FOR SUCH CONTROL. This warranty
excludes malfunctions or failures which were caused by repairs by persons not authorized by
us, mishandling, improper installation, modifications, or damage to the Control while in your
possession, or unreasonable use. This warranty does not apply to batteries or to deterioration
or damage to the product caused by the use of faulty batteries. To obtain a replacement, return
your Control postage prepaid along with proof of purchase to Hunter Fan Company Service
Department at 7130 Goodlett Farms Pkwy., Memphis, TN 38016. IN NO EVENT SHALL HUNTER
FAN COMPANY BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES. SOME STATES DO
NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION
OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS
OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS
AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
Read and Save These Instructions
This product conforms to UL Standard 1917.
This device complies with part 15 of the FCC Rules.
WARNINGS
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
This device complies with RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate the
receiving antenna, Increase the separation between the equipment and receiver,
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV technician
for help. Note: Any changes or modifications to the transmitter or receiver not
expressly approved by Hunter Fan Company may void one's authority to operate
this remote control. Chemical burn hazard. Keep batteries away from children.
This remote contains a lithium button cell battery. If a new or used lithium button/
coin cell battery is swallowed or enters the body, it can cause severe internal burns
and can lead to death in as little as 2 hours. Always completely secure the battery
compartment. If the battery compartment does not close securely, stop using the
product, remove the batteries, and keep it away from children. If you think batteries
might have been swallowed or placed inside any part of the body, seek immediate
medical attention. Dispose of cells properly and keep away from children. Even
used cells may cause injury.
If you are installing multiple remote-controlled fans
on the same circuit breaker,
you may need to perform a few extra steps to prevent interference or faulty operation of
your remote controls.
Go to www.HunterFan.com/FAQs and click "How do I properly install multiple remote-
controlled fans?" for more information.
Installation
Turning off the power
1
Before installation, use the pull chains to set the fan speed
to HIGH and the light to ON. Ensure the power is OFF at the
outlet box and wall switch location before proceeding with
installation.
2 Removing the canopy
Remove the canopy. If uncertain how to remove it, reference the
fan's owner's manual. With wiring exposed, it may be helpful
to note existing wire connections or take a digital photo for
reference. Remove the wire connectors that connect the wires
from the outlet box to the fan, leaving the grounding wires
connected.
Installing the receiver WARNING
3
Choose the hanging system that most
To avoid possible electrical shock, before
closely resembles the one used by your
installing your fan, disconnect the power by
fan, and install the receiver and wire as
turning off the circuit breakers to the outlet box
directed.
associated with the wall switch location.
You may have installation issues if the
fan is installed on an angled ceiling. For
assistance, call 1-888-830-1326.
Receiver
Receiver
Ceiling
Plate
OR OR Receiver OR
Canopy
Canopy
Canopy
Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire,
leaving a minimum of 8" remaining. Re-strip the fan lead wires 1/2". Place remaining excess wire into the ceiling
electrical box. The bracket and fan must remain properly grounded.
WARNING
4 Wiring the receiver to the fan
Using the orange wire connectors,
All wiring must be in accordance with national
connect the blue wire from the receiver
and local electrical codes ANSI/NFPA 70. If you
to the blue wire (or possibly black with
are unfamiliar with wiring or in doubt, consult a
white stripe wire) from the fan. Connect
qualified electrician.
the yellow wire from the receiver to the
black wire from the fan.
Note: If you are uncertain about wire colors or connections, please contact a qualified electrician.
blue blue
yellow
black
5 Wiring the receiver and fan to the ceiling
Using the orange wire connectors, connect the black wire
(ungrounded) from the ceiling to the black wire from the
receiver. Connect the white wire (grounded) from the ceiling
to both the white wire from the receiver and the white wire
from the fan.
OFF OFF
AFTER ALL WIRES ARE CONNECTED and secured with wire
connectors, re-install the canopy.
black black (ungrounded)
white
white white (grounded)
Turn the splices upward and push them carefully back through the hanger bracket into the outlet box. Spread the
wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of
the outlet box.
Installing the battery
6
Cable Tie
To access the battery compartment, remove the small
Ceiling
Bracket Phillips head screw that secures the battery door to the
remote control.
A
Fan Body
Replace the used battery with a CR2032 battery when
necessary. The battery should be installed with the positive
(+) side up.
7 Turning on the power
IMPORTANT
Use the pull-chain switch on the fan to set the fan speed to
the HIGH position before operation.
8
Reference the included remote function card for
information on how to use your control!
The remote transmitter is already paired to the receiver
and ready to use.
Note: If your need to pair your remote, cycle power to the fan by
turning power off and back on at the wall switch (or circuit breaker
if necessary). Within three minutes, press and hold both the Fan
button and the Light button for four seconds to pair the remote.
To prevent faulty operation, please disconnect power
from all other ceiling fans within range while pairing.
Remote Function Guide
Key Press
+ Quick Press
+ Long Press
+ Quick Press
+ Long Press
+ 2 x
Phillips
Head
Screw
Battery
Door
ON ON
M3859 • 1/21/21 • © 2021 Hunter Fan Company
Function
Light On/Off
Light Dimming
Fan On/Off
Dimming Mode
On/Off