Publicidad
CARE AND MAINTENANCE
All maintenance should only be carried out by a qualified technician.
Cleaning
Before cleaning or performing any maintenance, remove the battery pack from the impact driver.
For safe and proper operation, always keep the tool and its ventilation slots clean.
Always use only a soft, dry cloth to clean your impact driver; never use detergent or alcohol.
TROUBLESHOOTING
WARNING
• Place the direction-of-rotation selector (C) in the center lock position and detach the battery pack
from the impact driver before performing troubleshooting procedures.
PROBLEM
The driver does not work. The battery pack is depleted.
The bit cannot be
installed.
The motor is overheating. Be sure cooling vents are free of dust
The LED worklight blinks
rapidly.
The LED worklight blinks
slowly.
WARRANTY
For 5 years from the date of purchase, the impact driver is warranted for the original purchaser to
be free from defects in material and workmanship. This guarantee does not cover damage due to
abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or expendable
parts and accessories expected to become unusable after a reasonable period of use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at no
charge. This guarantee gives you specific legal rights, and you may also have other rights that
vary from state to state.
POSSIBLE CAUSE
1. The sleeve is not released.
2. The bit does not fit the sleeve.
and obstacles.
The tool has stopped working to
protect internal circuits.
The battery charge is very low.
13
CORRECTIVE ACTION
Charge the battery pack.
1. Release the sleeve.
2. Use a suitable adapter or
claimed capacity bit.
Clean and clear the vents. Do
not cover the vents with your
hand during operation.
Release the trigger switch,
wait for the tool to cool down,
then and start the tool again.
Charge the battery.
kobalttools.com
Publicidad
