Electrical Fuses; Accessories/Options; Use; Battery Check/Setting On A New Machine - KENT Razor Blade 26D Instrucciones De Uso

INSTRUCTIONS FOR USE

ELECTRICAL FUSES

Fuses
– The following fuses are located under the cover (1, Fig.
H):
– Low power circuit protection fuse (F3) (5A): (2, Fig.
H)
– Drive system electronic board protection fuse (F2)
(60A): (3, Fig. H)
– Function electronic board protection fuse (F1)
(100A): (4, Fig. H)

ACCESSORIES/OPTIONS

In addition to the standard components, the machine can be
equipped with the following accessories/options, according to
the machine specific use:
1. GEL batteries
2. Brushes of different materials
3. Oil-proof squeegee blades
4. Front and rear wheels of different materials
5. Flashing light
For further information concerning the above-mentioned
optional accessories, contact an authorized Retailer.
8

USE

While reading this Manual, the operator must pay particular
attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately
replace them if damaged.
BATTERY CHECK/SETTING ON A NEW
MACHINE
The machine requires one of the followings:
– One 24 V battery box, 240 Ah/C5 (WET)
– One 24 V battery box, 240 Ah/C5 (GEL) (optional)
– 4 6 V batteries, 180 Ah C5 (WET)
– 4 6 V batteries, 180 Ah C5 (GEL)
Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(2)2006-11
WARNING!
On some points of the machine there are some
adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
WARNING!
The electric components of this machine can
be seriously damaged if batteries are either
installed or connected improperly. The
batteries must be installed by qualified
personnel only. Set the function electronic
board and the built-in battery charger
according to the type of batteries used (wet or
gel batteries).
Check the batteries for damage before
installation.
Disconnect the battery connector and the
battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps
supplied with the machine.