ASROCK WOLFDALE1333-GLAN Manual página 15

All manuals and user guides at all-guides.com
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 22)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 10)
connect the blue end
to the motherboard
80-conductor ATA 66/100 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (PORT0):
see p.2, No. 15)
SATAII_3
(SATAII_2 (PORT1):
(PORT2)
see p.2, No. 14)
(SATAII_3 (PORT2):
see p.2, No. 12)
SATAII_1
(SATAII_4 (PORT3):
(PORT0)
see p.2, No. 13)
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)
Power Cable
connect to the SATA
(Optional)
HDD power connector
ASRock Wolfdale1333-GLAN Motherboard
the red-striped side to
Pin1
connect the black end
to the IDE devices
These Serial ATAII (SATAII)
connectors support SATAII
or SATA hard disk for internal
SATAII_4 storage devices. The current
(PORT3)
SATAII interface allows up to
3.0 Gb/s data transfer rate.
SATAII_2
(PORT1)
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
connect to
power cable to the power
the power
connector of the power supply.
supply
1 5 1 5 1 5 1 5 1 5